How to Configure Virtual Superintendent Load Tracking

The following are setup instructions for customers that have enabled the Virtual Superintendent Load Tracking license. These steps should be taken once the license is enabled to ensure the feature is working properly.

đź’ĄVirtual Superintendent Load Tracking is a premium product and requires a separate license. Please contact your Account Manager for more information on premium product licenses or reach out to Customer Support at help@tenna.com or call 888.836.6269.

How to Configure Assets in Virtual Superintendent

NOTE: Customers will chose which Tenna assets they would like to sync with VS during the contract phase. These assets will require a TennaCANbus, TennaFLEET II, or John Deere MTG tracker with the appropriate firmware.

Once eligible and chosen assets have been synced from Tenna to VS, there are a few key fields that must be configured for each asset before load tracking data is available. These fields include Role Check and Payload Capacity.

Important! There are many fields on these pages that may be blank or pre-filled. Do not add, edit, or delete any fields that are not specifically instructed below. It could result in Load Tracking not functioning properly.

1

Click "Menu" in the top right hand corner of Virtual Superintendent.

2

Select "Assets".

3

Select any asset.

4

Click "Edit".

Role Check (Required)

Each asset should have it’s appropriate role selected when counting loads. Selecting the role will identify the behavior expected from the asset:

  • Loaders: Excavators, Loaders, 4-Wheel Loaders, etc.
  • Haulers: Articulated Dump Truck, Heavy Truck, Rigid Truck, etc.

NOTE: The role should be automatically selected based on Tenna category type. This step is important to ensure that role was selected appropriately.

1

On the Configuration tab, ensure the asset has the correct load count role selected: Load Count - Loader or Load Count - Hauler.

2

Click "Save".

Payload Capacity (Required)

Payload Capacity is needed in order to estimate material movement for your load tracking equipment.

1

On the Weights & Limits tab, enter an Approximate Payload and appropriate Payload Unit for the asset.

NOTE: Payload Unit options include tons or cubic yards.

2

Click "Save".

How to Configure Sites/Jobs in Virtual Superintendent

Project Sites in Tenna that are synced with Virtual Superintendent will initially have an “Upcoming” status. In order for your Tenna Sites (VS Jobs) to produce Load Tracking data, they must be marked as “In Progress”. The instructions below show you how to start a job.

1

Click "Menu" on the right hand side, then select "Jobs".

2

Click on a Job with an "Upcoming" status.

3

Click Start".

4

Click "Start" again to confirm.

5

The Job should now show as "In Progress".

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us